Unable to decode raw message RawMessage cause 100% ProcessBuffer [Solved Partial]

[rafaelcarsetimo]

@jochen.

The raw messages solve the error in decode. But the process continues stop:

Graylog Cluster, Buffer process 100% stop process messages

Hello Sirs, I know there are several reports of this case, but I am following all the possibilities that I found in the forum, but without success. Basically, I have 3 nodes. They have a processing capacity each at about 1600m / s. But intermittently one of them stop process the messages but still send to journal… and the only way to re-process is to restart the Graylog service. But after doing this, a few minutes later, another node stops processing the messages and again I have to restart th…